Laser-induced breakdown spectroscopy; Fluid jets; Laser ablation; Copper; Plasma jets;

A complex optimization of geometrical and temporal parameters of a jet system (developed in Laser-induced breakdown spectroscopy (LIBS) laboratory of Brno University of Technology) for direct elemental analysis of samples in a liquid state of matter using LIBS was carried out. First, the peristaltic pump was synchronized with the flashlamp of the ablation laser, which reduced variation of the ablated sample amount. Also, the fluctuation of the laser ray angle incident on the jet surface was diminished. Such synchronization reduced signal standard deviations and thus increased repeatability of the measurements. Then, laser energy and distance of the focusing lens from the sample were optimized. The gate delay time and the gate width were optimized for single pulse (SP) experiments; the gate delay time and the inter-pulse delay were optimized for the use of double pulse (DP) variant. Results were assessed according to the highest signal to noise ratios and the lowest relative standard deviations of the signal. The sensitivity of the single pulse and the double pulse LIBS for the detection of heavy metals traces, copper (Cu i at 324.754 nm) and lead (Pb i at 405.781 nm), in aqueous solution of copper (ii) sulfate and lead (ii) acetate, was estimated in terms of limits of detection (LODs). As a result, sensitivity improvement of DP LIBS system was observed, the LOD of Cuobtained with DP was calculated 40% lower than LOD gained from SP technique.

Laser-induced breakdown spectroscopy; Aluminium; Charge coupled devices; Magnesium; Light diffraction;

This contribution introduces a new type of setup for fast sample analysis using laser-induced breakdown spectroscopy (LIBS). The novel design combines a high repetition rate laser (up to 50 kHz) as excitation source and an acousto-optical modulator (AOM) as a fast switch for temporally gating the detection of the emitted light. The plasma radiation is led through the active medium of the AOM where it is diffracted on the transient ultrasonic Bragg grid. The diffractedradiation is detected by a compact Czerny-Turner spectrometer equipped with a CCD line detector. Utilizing the new combination of high repetition rate lasers and AOM gated detection, rapid measurements with total integration times of only 10 ms resulted in a limit of detection (LOD) of 0.13 wt.% for magnesium in aluminum alloys. This short integration time corresponds to 100 analyses/s. Temporal gating of LIP radiation results in improved LODs and consecutively higher sensitivity of the LIBS setup. Therefore, an AOM could be beneficially utilized to temporally detect plasmas induced by high repetition rate lasers. The AOM in combination with miniaturized Czerny-Turner spectrometers equipped with CCD line detectors and small footprint diode pumped solid state lasers results in temporally gateable compact LIBS setups.

Single pulse (SP) LIBS setup was modified to DP setup to achieve more accurate analytical sensitivity and spatial resolution. All parameters, like interpulse delay, acquisition delay or energy of ablation and excitation laser pulses were optimized.

The development of a remote laser-induced breakdown spectroscopy (LIBS) setup with an off-axis Newtonian collection optics, Galilean-based focusing telescope, and a 532 nm532 nm flattop laser beam source is presented. The device was tested at a 6 m6 m distance on a slice of bone to simulate its possible use in the field, e.g., during archaeological excavations. It is shown that this setup is sufficiently sensitive to both major (P, Mg) and minor elements (Na, Zn, Sr). The measured quantities of Mg, Zn, and Sr correspond to the values obtained by reference laser ablation–inductively coupled plasma–mass spectrometry (LA-ICP-MS) measurements within an approximately 20% range of uncertainty. A single point calibration was performed by use of a bone meal standard . The radial element distribution is almost invariable by use of LA-ICP-MS, whereas the LIBS measurement showed a strong dependence on the sample porosity. Based on these results, this remote LIBS setup with a relatively large (350 mm350 mm) collecting mirror is capable of semiquantitative analysis at the level of units of mg kg-1.

Laser-ablation based spectrochemical Analytical Methods could be used in applications in which the capability for spatially resolved analysis is required. Such analysis gives a 2-D or 3-D map of the monitored chemical elements. Here we introduce automation of a 2-D surface analysis in the laser-induced breakdown spectroscopy setup by implementation of an autofocus algorithm based on the evaluation of the image sharpness. The most suitable algorithm with respect to its speed, accuracy, and durability against digital noise is chosen by testing different gradient-based methods and methods working in the frequency domain.

laser induced breakdown spectroscopy; LIBS; double pulse LIBS; plasma characterization; time resolved measurement; ICCD; photomultiplier;

In this study, we present orthogonal re-heating double pulse experimental system equipped with both ICCD and PMT detection and preliminary measurements of temperatures of plasmas generated on an iron sample.