In general, the detection of F and other halogens is challenging through conventional techniques. In this paper, various approaches for the qualitative and quantitative analysis of F using the laser-induced breakdown spectroscopy (LIBS) technique were demonstrated. In LIBS, fluorine detection can be realized by means of atomic lines and molecular bands. For the purposes of our experiment, two sets of pellets with various contents of CaF2, CaCO3 and cellulose were analyzed using a lab-based LIBS system under a He atmosphere. The fluorine atomic line at 685.60 nm was correlated with CaF signals proving their close relationship. Consequently, the limits of detection were determined for both analytical signals. Moreover, conditions necessary for the quantification of F via CaF band signals were estimated. The dependence of the CaF signal on the varying ratio of Ca and F contents was investigated. Finally, a chip of a real CaF2 crystal was prepared and its surface was mapped with Raman and LIBS systems. The obtained elemental and molecular maps showed good numerical correlations. Thus, the yielded results validated the possibility to substitute the fluorine atomic line by non-conventional CaF molecular bands in the qualitative and quantitative LIBS analysis of fluorine.

Laser-Induced Breakdown Spectroscopy; Silver nanoparticles; Low pressure conditions; Sensitivity improvement;

In this work we studied the effect of vacuum (low pressure) conditions on the behavior of laser-induced plasma (LIP) created on a sample surface covered with silver nanoparticles (Ag-NPs), i.e. Nanoparticles-Enhanced Laser-Induced Breakdown Spectroscopy (NELIBS) experiment in a vacuum. The focus was put on the step by step optimization of the measurement parameters, such as energy of the laser pulse, temporally resolved detection, ambient pressure, and different content of Ag-NPs applied on the sample surface. The measurement parameters were optimized in order to achieve the greatest enhancement represented as the signal-to-noise ratio (SNR) of NELIBS signal to the SNR of LIBS signal. The presence of NPs involved in the ablation process enhances LIP intensity; hence the improvement in the analytical sensitivity was yielded. A leaded brass standard was analyzed with the emphasis on the signal enhancement of Pb traces. We gained enhancement by a factor of four. Although the low pressure had no significant influence on the LIP signal enhancement compared to that under ambient conditions, the SNR values were noticeably improved with the implementation of the NPs.